How To Make A Robot At Home- TRP

In this article, we will guide you on how to make a simple robot at home. Just follow these super-simple steps.   

How To Make A Robot At Home- TRP



Hello Friends, In this article, we will be making a remote-controlled robot.

This robot is really fun to play with and most of all it is very simple to make

To make this robot we will need-


  • A small plastic box with a lid
  • Two 3v toys DC motors of similar specifications
  • Two LEDs of the same color
  • Two pushbuttons
  • About 2-3m of four different color wires
  • Li-Ion cell Holder

In this, we will be using Li-Ion cells as power source

Follow these super-simple steps to make a simple toy robot at home-

  • Take the plastic box Using Hot Glue, paste both the motors on the lid Make sure they are in center and opposite to each other
  • Mark the position of motors on the boundary of the box Cut a slit on both sides, so that the box closes well
  • Now, solder the LED to the motors These LEDs will act as the eyes
  • Mark and make holes to insert the LEDs
  • Also, make a hole at the back to insert the wires
  • Solder the wires to the motor
  • Pass the wire through the hole insert the LEDs and close the box
  • Now, take the cell holder and the two buttons Solder both the buttons at the back of the holder
  • Now, pay attention to the polarity Connect both the -ve wires together Solder them to a -ve terminal of battery holder Solder the +ve wires to the buttons
  • Secure the wires using Hot Glue Connect the two-button terminals together using a small wire, make the connection between the +ve terminal of the battery holder and the buttons
  • Now, Pay attention to the polarity and insert the cells in parallel
  • Press the buttons and test the working of all the components
  • If everything works fine, it is now time to make the wheels
  • From a piece of cardboard, cut 4 wheels off about 4cm in diameter
  • Using Hot Glue, Paste two pieces over one another to make two pair of wheels Apply some Hot Glue and smooth the eyes
  • From a plastic pen, carefully cut few circles
  • Also, cut a Balloon to get the rubber grip for the wheels Attach the wheels to the motors and secure them with the glue or plastic circles
  • Our Toy Robot is now ready Use the remote and test the working of the robot If everything works well, apply some tape over the wires on the remote

So Guys, If you liked reading this article then share it with your friends

Thanks for Reading.

0 Comments